Gertboard Arrived!

My gertboard arrived today! So I setup the soldering stuff and went to work on the practice board from Elenco that I bought from Amazon. And I found out real quick that the soldering iron that I have is not high enough quality. The tip did not get evenly hot which made it hard to solder. So I decided to buy a different soldering iron. I bought this one from Adafruit as they have Raspberry Pi and lots of other awesome electronics and DIY kits/parts. So I am assuming that since they say that this soldering iron is a good entry-level tool that it should be worth it. So now the only problem is waiting for that to ship…

I was looking up some instructional videos about the gertboard and came across these three from Element14.

Advice about assembly – Surface mount – Through hole

And as mentioned in this video at approximately 6:10 he says that there was only 10 jumper wires that came with the kit, and there are 12 LEDs. So there is not enough jumper cables to connect all 12 LEDs at the same time. So in addition to the soldering iron I bought a pack of these F/F jumper wires and also a pack of M/M jumper wires.  This gives me the option of creating my own M/F jumper wires by combining one of each. And these come in packs of 40 so I should have plenty!

Adafruit is a really awesome website. And Sparkfun is really amazing too!

Here is a picture of what all arrived in the package from Newark. Gertboard on the left. Small components in bags in the center. And some of the bigger chips in anti-static bags on the right.

Next two images are of the GPIO cable coming out of the case that I posted about previously.

The next two images are of the bare Gertboard. First one is the top of the board, and the second is the bottom of the board.